Eaton Electrical Extended Battery Module (EBM) 9140 Uživatelský manuál stáhnout pdf (Strana 23)

INSTALLATION

EATON Powerware

9140 EBM User’s Guide S 164201623 Rev A FINAL DRAFT 2006 July 14

EBM Setup

The Powerware 9140 EBM comes with all hardware required for

installation in a standard EIA or JIS seismic rack-mount configuration

with square or round mounting holes. The rail assemblies adjust to

mount in 19-inch panel racks from 24 to 30 inches deep.

Checking the EBM Accessory Kit

Verify that the following items are included with the EBM:

S Mounting brackets and fasteners (if not already installed):

- (2) front mounting brackets

- (2) rear mounting brackets

- (12) M4 flat-head screws, plus (2) extra

S Rails and fasteners:

- (2) sliding r ail assemblies (left and right)

- (4) adapter plates (for 7.1 mm round hole)

- (4) adapter plates (for 9.5 mm square hole)

- (16) M5 machine screws, plus (2) extra

- (2) M6 machine screws, plus (2) extra

- (2) M6 clip nuts for racks with round holes, plus (2) extra

- (2) M6 cage nuts for racks with square holes, plus (2) extra

- (8) M4 machine screws with (8) M4 locknuts, plus (2) extra of each

S EBM user’s guide

S Optional seismic mounting brackets and fasteners:

- (2) EBM seismic mounting brackets

- (4) wing bolts, plus (1) extra

- (4) M6 machine screws

NOTE Discard the EBM user’s guide if you are installing the EBM with a new UPS at the

same time. Use the UPS user’s guide instead to install both the UPS and the EBM.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Žádné komentáře

Eaton Electrical Extended Battery Module (EBM) 9140 Uživatelský manuál Strana 23